LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Anti-Lock Brake System) >> Repair Instructions >> Yaw Rate Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the OFF position.
  2. Remove the IP accessory trim plate. Refer to INSTRUMENT PANEL ACCESSORY TRIM PLATE & KNEE BOLSTER .
  3. Disconnect the yaw rate sensor connector.
  4. Loosen the two yaw rate sensor nuts (1).
  5. Remove the yaw rate sensor (2).
    Fig 1: Removing Yaw Rate Sensor Nuts
    G01728641Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals