LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Anti-Lock Brake System) >> Repair Instructions >> Brake Fluid Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition OFF.
  2. Drain the cooling system. Refer to DRAIN & REFILL COOLING SYSTEM.
  3. Disconnect and remove the radiator inlet hose.
  4. Loosen the two retaining nuts (1) and carefully reposition the EBCM to access the brake pressure sensor (2).
  5. Disconnect the brake pressure sensor electrical connector.
  6. Remove the brake pressure sensor from the vehicle.
    Fig 1: Removing EBCM Insulator Nuts
    G01728631Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals