Scan Tool Output Controls

Scan tool can be used to test individual gauges and indicators on the instrument panel cluster under scan tool outputs. Turn ignition on, engine off, doors and hatch closed and ensure parking brake is not applied while performing procedure. Fuel pump can also be tested using this function under engine output controls.

• Chime Test  - Chime will sound at slow, medium and fast speed depending on priority.
• Coolant Gauge Sweep Test  - IPC will move gauge needle at or more than 260°F (125°C) when UP is selected. IPC will move gauge needle at or less than 100°F (38°C) when DOWN is selected.
• Fuel Gauge Sweep Test  - IPC will move gauge needle at or more than full when UP is selected. IPC will move gauge needle at or less than empty when DOWN is selected.
• Lamp Test  - IPC will illuminate the following indicators when ON is selected. IPC will turn the following indicators off when OFF is selected.
  • ABS
  • AIR BAG
  • BRAKE
  • CHECK GAUGES
  • MPH
  • SECURITY
  • TRACTION
• Oil Gauge Sweep Test  - IPC will move gauge needle at or more than 80 psi. (552 kPa) when UP is selected. IPC will move gauge needle at or less than zero psi (0 kPa) when DOWN is selected.
• Speed Gauge Sweep Test  - IPC will move gauge needle at or more than 200 MPH when UP is selected. IPC will move gauge needle at or less than zero MPH when DOWN is selected.
• Switch Dimming Test  - IPC will illuminate the dimming circuit to its brightest point when ON is selected. IPC will turn off the dimming when OFF is selected.
• Tach Gauge Sweep Test  - IPC will move gauge needle at or more than 7000 RPM when UP is selected. IPC will move gauge needle at or less than zero RPM when DOWN is selected.
• Volts Gauge Sweep Test  - IPC will move gauge needle at or more than 18 volts when UP is selected. IPC will move gauge needle at or less than 8 volts when DOWN is selected.
• Fuel Pump  - PCM will turn fuel pump on when ON is selected. PCM will turn fuel pump off when OFF is selected.