LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 231 (Supplemental Inflatable Restraint System) >> Repair Instructions >> SIR Disabling and Enabling Zone 2 >> Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition switch.
    2. Fig 1: Locating Roof Rail Module Connector
    GM899820Courtesy of GENERAL MOTORS CORP.
  2. Connect the roof rail module - left connector to the vehicle harness connector.
  3. Install the CPA to the roof rail module - left connector.
  4. Install the garnish molding to the upper lock pillar. Refer to Garnish Molding Replacement - Rear Upper in Interior Trim.
  5. Install the AIR BAG fuse into the body control module fuse center.
  6. Install the body control module fuse center cover.
  7. Use caution while reaching in and turn the ignition switch to the ON position.

    The AIR BAG indicator will flash then turn OFF.

  8. Perform the Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals