LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> C3500 HD 8.1 G, Automatic >> Repair and Diagnosis >> Steering >> Steering Linkage (Non-Rack & Pinion) >> Repair Instructions >> Idler Arm Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Idler Arm, Frame Bolts & Nuts
    GM340442Courtesy of GENERAL MOTORS COMPANY
  1. Position the idler arm (2) on the frame.
  2. Refer to Fastener Notice .

    Install the frame bolts (3) and the nuts (1) to the idler arm.

    Tighten 

    Tighten the frame bolts or nuts to 99 N.m (73 lb ft).

    3. Fig 2: Steering Linkage Components
    GM340481Courtesy of GENERAL MOTORS COMPANY
  3. Install the relay rod (9) to the idler arm ball stud (1).

    Ensure the seal is on the stud.

    4. Fig 3: Seating The Idler Arm Tapers
    GM689037Courtesy of GENERAL MOTORS COMPANY
  4. Use the J 29193  in order to seat the tapers.

    Tighten 

    Tighten the J 29193  or the J 29194  to 54 N.m (40 lb ft) in order to seat the tapers.

  5. Install the new idler arm ball stud prevailing torque nut to the idler arm ball stud.

    Tighten 

    Tighten the nut to 62 N.m (46 lb ft).

  6. Install the engine protection shield, if equipped. Refer to Engine Protection Shield Replacement .
  7. Lower the vehicle.
  8. Check the wheel alignment. Refer to Wheel Alignment Measurement .
scientia non olet · About LEMON Manuals