LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2000 >> Venture LS, Van Passenger Extended >> Repair and Diagnosis >> Body & Frame >> Windows >> Power Window System >> Removal & Installation >> Window Motor >> Removal & Installation

Removal & Installation

  1. Remove window switch and lock switch. See WINDOW SWITCH . Remove armrest screws. Feed power controls through panel. Using Door Trim Pad & Garnish Clip Remover (J-38778), release trim panel retainers from door and pry trim panel from door frame at window seal.
  2. Remove protective water shield. Raise window to fully closed position, and tape securely in place. Disconnect electrical connector from regulator motor.
  3. Using grease pencil or marker, draw line through center of counterbalance spring to aid in reinstallation and orientation. Using Door Module Coil Spring Tension Remover (J-38864), release regulator spring tension. Remove window motor from lock module. To install, reverse removal procedure. Lubricate motor drive gear and regulator sector teeth.
scientia non olet · About LEMON Manuals