Power Sliding Door Inoperative

NOTE: PSD will not operate if PSD is currently in diagnostic mode.

If the PSD does not operate electronically, one or more of the following conditions may have occurred:
- Vehicle battery was disconnected and reconnected.
- Vehicle battery was drained and recharged.
- RADIO fuse (10-amp) was removed and replaced.
If any of these conditions have occurred, PSD must be re-initialized. See POWER SLIDING DOOR REINITIALIZATION under PROGRAMMING.
If the open/close button on the overhead console, the "B" pillar or the remote keyless entry remote will not open/close the PSD, there is a problem in the Light Blue wire between the remote control door lock receiver, the rear side door actuator control module, "B" pillar open/close switch and overhead open/close switch. See WIRING DIAGRAMS . Perform power sliding door system check. See POWER SLIDING DOOR SYSTEM CHECK .