Preliminary Inspection

Before proceeding with any electrical trouble shooting, perform a mechanical inspection first. Some major items to include are:

• Ensure both ends of cruise control cable are connected to actuator and accelerator pedal assembly.
• Ensure cruise control servo cable and accelerator pedal move freely and do not bind.
• Check cruise control servo for bare, broken, or disconnected wires or connectors.
• Check FI fuse (15-amp), located in fuse block in right side of engine compartment.
• Check STOP fuse (15-amp), located in fuse block behind left kick panel.
• Ensure ground connections are clean and tight.
• Repair any Diagnostic Trouble Codes (DTCs) before trouble shooting cruise control system.
• Ensure speedometer and Vehicle Speed Sensor (VSS) are operating properly.
• Check cruise control indicator bulb for open or shorted filament.

If no obvious problems are found during inspection, proceed to SYSTEM TESTS  .