Accumulator Assembly: Installation
WARNING: This page is about a different car, the 2001 GMC Safari, 2001 Chevrolet Astro, 2000 GMC Safari, and 2000 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Tools required: (J25025-B) Pump and Valve Body Alignment Pin Set (J-36850) and Transjel® transmission assembly lubricant.
- Install the 3-4 accumulator pin into the transmission case. Install the 3-4 accumulator piston onto the pin. The piston legs must face the valve body. Install the 3-4 accumulator piston oil seal ring. Install the 3-4 accumulator piston spring. See Fig 5. Install the (J25025-B) to the transmission case.
- Install the case gasket and the valve body gasket to the spacer plate. The case gasket is identified by a "C". The valve body gasket is identified by a "V". Use the (J-36850) to retain the gaskets to the spacer plate. Install the spacer plate and the gaskets to the transmission case. See Fig 4.
- Install the oil pass cover and the oil pass cover bolts. Tighten the bolts to specification. See TORQUE SPECIFICATIONS .
- Install the 1-2 accumulator piston with the piston legs facing toward the case. See Fig 2. Install the oil seal ring to the accumulator cover.
- Install the 1-2 accumulator spring onto the piston. Install the 1-2 accumulator cover and the cover bolts. Tighten the bolts to specification. See TORQUE SPECIFICATIONS .
- Remove the (J25025-B) from the transmission case. Install the control valve body. See VALVE BODY & PRESSURE SWITCH .