Disabling System
WARNING:
SDM maintains sufficient voltage to cause air bag deployment for up to 2 minutes after ignition switch is turned OFF, battery is disconnected, or fuse powering SDM is removed. In order to begin servicing immediately, inflator modules must be removed from deployment loop.
NOTE:
When AIR BAG fuse is removed and ignition switch is in RUN position, AIR BAG warning light will be on. This does not indicate a system malfunction.
- Turn steering wheel to place vehicle wheels in straight-ahead position. Remove key from ignition. Remove IGN fuse (7.5-amp) and CIG fuse (15-amp) from junction block, located near base of steering column.
- Release and unlock SIR coil Yellow 2-pin connector. See Fig 1.
- Remove glove box. Release, unlock and disconnect passenger-side air bag Yellow 2-pin connector. See Fig 2.
- Release, unlock and disconnect driver and passenger"s seat air bag connectors located under seats.