LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2000 >> Malibu Base >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> Diagnostic Tests >> DTC B2533: Front FOGLIGHT Relay Output Short To Battery >> Testing

DTC B2533: Front FOGLIGHT Relay Output Short To Battery: Testing

  1. If Body Control Module (BCM) diagnostic system check has been performed, go to next step. If Body Control Module (BCM) diagnostic system check has not been performed, go to BODY CONTROL MODULE (BCM) DIAGNOSTIC SYSTEM CHECK  under SYSTEM TESTS.
  2. Connect scan tool to Data Link Connector (DLC), located to left of steering column. Turn ignition on. Using scan tool, command foglight OFF and ON. If relay does not turn on and off, go to next step. If relay turns on and off, go to DIAGNOSTIC AIDS  .
  3. Turn ignition off. Remove fog light relay from right instrument panel junction block. Turn ignition on. Using a test light connected to ground, probe relay cavity terminal No. 86. If test light illuminates, go to next step. If test light does not illuminate, go to step  10 .
  4. Connect a test light between relay cavity terminals No. 86 and No. 85. Using scan tool, command foglight OFF and ON. If test light does not turn on and off, go to next step. If test light turns on and off, go to step  8 .
  5. If test light stays off, go to next step. If test light stays on, go to step  7 .
  6. Check for short to power on Dark Green/White wire between right instrument panel junction block connector C1 terminal F3 and BCM connector C1 terminal A2. See Figure . If circuit is okay, go to step  9 . If circuit is shorted to power, repair as necessary. After repair, go to step  13 .
  7. Check for short to ground on Dark Green/White wire between right instrument panel junction block connector C1 terminal F3 and BCM connector C1 terminal A2. If circuit is okay, go to step  9 . If circuit is shorted to ground, repair as necessary. After repair, go to step  13 .
  8. Check fog light relay and cavity terminals for damage and poor connections. If no problem is found, go to step  11 . If connections are poor, repair as necessary. After repair, go to step  13 .
  9. Check BCM and harness connector terminals for damage and poor connections. If no problem is found, go to step  12 . If connections are poor, repair as necessary. After repair, go to step  13 .
  10. Repair power feed circuit to foglight relay. See POWER DISTRIBUTION article in WIRING DIAGRAMS. After repair, go to step  13 .
  11. Replace foglight relay. Go to step  13 .
  12. Replace BCM. See BODY CONTROL MODULE (BCM)  under REMOVAL & INSTALLATION. Program BCM. See BODY CONTROL MODULE (BCM)  under PROGRAMMING. After repair, go to next step.
  13. Reconnect all disconnected components and connectors. Clear DTCs. Operate vehicle under conditions that set DTC. If DTC resets, go to step  2 . If DTC does not reset, system is okay.
scientia non olet · About LEMON Manuals