Disabling & Activating Air Bag System
WARNING:
Supplemental Inflatable Restraint (SIR) SDM retains back-up voltage for about 10 minutes after disabling SIR system. Wait minimum of 10 minutes after disabling SIR before servicing steering column components. Servicing steering column components before 10 minutes has elapsed may cause accidental deployment of air bag and possible personal injury.
- Before proceeding, follow air bag service precautions. See SERVICE PRECAUTIONS . To disable air bag, turn ignition switch to LOCK position and remove key. Remove SIR fuse (air bag fuse) from instrument panel fuse block. Remove left hand instrument panel sound insulator. Remove Connector Position Assurance (CPA) clip from Yellow 2-pin SIR harness connector at base of steering column. If equipped with passenger side airbag, remove right side panel and unhook CPA from passenger SIR. All SIR system connectors use CPA clips to ensure connector retention. Disconnect Yellow 2-pin SIR connector. Wait at least 10 minutes before working on vehicle.
- With SIR fuse removed and ignition on, AIR BAG warning indicator light will be on. This is normal operation for SIR system and does not indicate fault code or system problem.
- To activate air bag system, ensure ignition is in OFF position. Connect Yellow 2-pin SIR connector and CPA clip at base of steering column, and passenger SIR CPA clip if equipped. Install SIR fuse. Turn ignition switch to RUN position. Observe AIR BAG warning indicator light. Light should flash 7 times, then go out. If AIR BAG warning indicator light does not function as described, a malfunction exists in air bag system.