Test J: Rear Door Lock/Unlock Inoperative With Transmitter

Test transmitter operation. See TRANSMITTER TEST under COMPONENT TESTS. Go to next step.
Disconnect rear door lock actuator motor. Connect a test light between rear door lock actuator motor connector terminal "A" (Tan wire) and ground. Lock all doors at any power door lock switch. If test light is on, go to next step. If test light is off, go to step 4 .
Connect a test light between rear door lock actuator motor connector terminal "B" (Gray wire) and ground. Unlock all doors at any power door lock switch. If test light is on, go to step 5 . If test light is off, go to step 6 .
Disconnect Remote Control Door Lock Receiver (RCDLR). Using DVOM, check continuity between rear door lock actuator motor connector terminal "A" (Tan wire) and ground. If continuity exists, go to step 7 . If continuity does not exist, go to step 8 .
Replace rear door lock actuator motor. See appropriate POWER DOOR LOCKS article. Go to step 11 .
Repair open in Gray wire between rear door actuator motor and splice S244. Go to step 11 .
Repair short to ground in Tan wire and Black wire between RCDLR and rear door lock actuator motor. Go to step 11 .
Connect a fused jumper wire between battery power and RCDLR connector terminal "G" (Black wire). See Figure . Connect a test light between rear door lock actuator motor connector terminal "A" and ground. If test light is on, go to next step. If test light is off, go to step 10 .
Replace RCDLR. See REMOTE CONTROL DOOR LOCK RECEIVER under REMOVAL & INSTALLATION. Reprogram replacement RCDLR to transmitter(s). See PROGRAMMING . Go to step 11 .
Repair open in Black wire and Tan wire between RCDLR and rear door actuator motor. Go to next step.
Operate system to verify repair.