Test B: All Doors Unlock Inoperative With Transmitter
- Test transmitter operation. See TRANSMITTER TEST under COMPONENT TESTS. Go to next step.
- Disconnect Remote Control Door Lock Receiver (RCDLR). Connect a test light between RCDLR connector terminal "E" (Orange wire) and ground. See Figure . If test light is off, go to next step. If test light is on, go to step 4 .
- Repair open in Orange wire between RCDLR and instrument panel fuse block. Go to step 11 .
- Connect a test light between RCDLR connector terminal "F" (Orange wire) and ground. See Figure . If test light is off, go to next step. If test light is on, go to step 6 .
- Repair open in Orange wire between RCDLR and instrument panel fuse block. Go to step 11 .
- Using DVOM, check continuity between RCDLR connector terminal "N" (Black wire) and ground. See Figure . If continuity does not exist, go to next step. If continuity does exist, go to step 8 .
- Repair open in Black wire between RCDLR connector and ground. Go to step 11 .
- Disconnect power door lock control module. Using DVOM, check continuity between RCDLR connector terminal "B" (White wire) and power door lock control module connector terminal "D" (White wire). See Figure . If continuity exists, go to next step. If continuity does not exist, go to step 10 .
- Replace RCDLR. See REMOTE CONTROL DOOR LOCK RECEIVER under REMOVAL & INSTALLATION. Go to step 11 .
- Repair open in White wire between RCDLR and power door lock control module. Go to next step.
- Operate system to verify repair.