LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2000 >> Chevy Express G3500, Van Cargo Extended, 5.7 R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System Self-Diagnostics - Diesel) >> Removal & Installation >> Engine Shutdown Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing/Installing ESO Solenoid
    GM377146Courtesy of GENERAL MOTORS CORP.
  1. Install the new O-ring on the ESO solenoid.
    2. NOTE: Refer to Component Fastener Tightening Notice in Cautions and Notices.
  2. Install the ESO solenoid in the injection pump.

    Tighten:  Tighten the solenoid (external hex or internal hex) to 25 N.m (18 lb ft).

  3. Install the ESO electrical connector.
  4. Start the engine and check for leaks.
scientia non olet · About LEMON Manuals