LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2000 >> C3500 HD 6.5 F, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 739 (Body Front End) >> Repair Instructions >> Fender Replacement - Front Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the fender to vehicle.
  2. Install the rear lower fender bolt. Tighten the rear lower fender bolt to 25 N.m (18 lb ft).
  3. Install the fender to radiator support bolts and retainer. Tighten the radiator support bolts to 25 N.m (18 lb ft).
  4. Connect the left front grille clip to the fender.
  5. Install the fender to door hinge bolts. Tighten the door hinge bolts to 25 N.m (18 lb ft).
  6. Install the fender to upper cowl bracket bolt. Tighten the upper cowl bracket bolts to 25 N.m (18 lb ft).
  7. Install the push-in retainers (2) in order to attach the wheelhouse panel (1) to the fender (3).
  8. Install the underhood electrical center.
  9. Connect the windshield washer hose to the clips on the fender.
  10. Connect the hood latch release cable to the clips.
  11. Install the battery tray.
  12. Install the wheelhouse panel bracket. Tighten the wheelhouse bracket nuts and bolts to 25 N.m (18 lb ft).
  13. Install the left fender to cowl support brace. Tighten the cowl support brace bolts to 9 N.m (80 lb in).
  14. Install the left hood spring assembly. Tighten the hood spring bolt to 25 N.m (18 lb ft).
  15. Install the hood. Refer to Hood Replacement .
  16. Install the left outboard cowl vent grille trim piece.
  17. Connect the negative battery cable.
scientia non olet · About LEMON Manuals