"LOCK" Function Inoperative With Transmitter On All Doors
NOTE:
A short to ground will cause an open fuse. Check fuse for an open. See WIRING DIAGRAMS
.
- Disconnect remote control door lock receiver connector. Connect test lamp between door lock receiver connector terminals "P" and "R". See Fig 1 . If all doors lock, replace remote control door lock receiver. If all doors do not lock, go to next step.
- Reconnect remote control door lock receiver connector. Using a fused jumper wire, backprobe between left instrument panel electrical center connector C3 (30-pin Black connector) terminal B3 and battery positive voltage. See Figure . If all doors lock, repair open in Light Blue wire between remote control door lock receiver and left instrument panel electrical center and retest system. If all doors do not lock, replace left instrument panel electrical center and retest system.