LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Venture Base, Van Passenger Extended >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Tests W/Codes >> Diagnostic Trouble Codes >> DTC P1351 - Ignition Control (Ic) Circuit Open >> Diagnostic Procedures

Diagnostic Procedures

  1. Perform POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK , then go to next step.
  2. Turn ignition off. Disconnect PCM harness connector. Check resistance between IC and reference low circuit. If resistance is less than 500 ohms, go to step 4). If resistance is not less 500 ohms, go to next step.
  3. Disconnect ICM harness connector. Check for open in IC circuit. Repair as necessary. After repairs, go to step 8). If circuit is okay, go to step 5).
  4. Check for poor terminal connections at PCM. Repair as necessary. After repairs, go to step 8). If connections are okay, go to step 7).
  5. Check for poor terminal connections at ICM. Repair as necessary. After repairs, go to step 8). If connections are okay, go to next step.
  6. Replace ICM. After replacing module, go to step 8).
  7. Replace PCM. Program replacement PCM using required equipment. After replacing PCM, go to next step.
  8. Read and record FAIL RECORDS data for this DTC. Clear DTCs. Operate vehicle within conditions noted in FAIL RECORDS data. Using scan tool, read SPECIFIC DTC. If scan tool displays DTC FAILED THIS IGN, return to step 2). If scan tool does not display DTC FAILED THIS IGN, repair is complete.
scientia non olet · About LEMON Manuals