LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1998 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle Overhaul & Testing - 4T60-E >> Transaxle Disassembly >> Final Drive Carrier Assembly

Final Drive Carrier Assembly

  1. Rotate output shaft until "C" ring opening is visible from beneath lower tapered end of transaxle case. Using "C" Ring Remover/Installer (J-34757), push "C" ring partially off shaft, then rotate shaft and remove ring with needle-nose pliers. Ring can also be removed with 2 long thin screwdrivers. Remove output shaft.
  2. Check final drive end play. See FINAL DRIVE CARRIER ASSEMBLY  under COMPONENT DISASSEMBLY & REASSEMBLY. See Figure . Remove final drive carrier assembly and selective thrust washer and bearing. Remove final drive internal gear snap ring and internal gear from case. See Figure .
scientia non olet · About LEMON Manuals