Wipers Operate Intermittently
CAUTION:
If front wiper/washer system works intermittently, or is completely inoperative, refer to SPECIAL POLICY ADJUSTMENT - WINDSHIELD WIPER MOTOR FAILURES
Service Campaign Bulletin 02054A dated May 9, 2003 prior to making repairs.
- Remove WIPER fuse from instrument panel fuse block. Connect a 0-30 amp ammeter across the fuse block terminals where the WIPER fuse was located. Turn ignition ON and wiper switch to HIGH position with windshield dry. Note the lowest current draw reading.
- If current draw is more than 5 amps, go to next step. If current draw is less than 5 amps, replace wiper motor. See WIPER MOTOR under REMOVAL & INSTALLATION.