Both Mirrors Do Not Operate
- Disconnect power mirror switch connector C1 (Black). Connect test light between power mirror switch connector terminals "D" (Orange wire) and "A" (Black wire). If test light does not glow, go to next step. If test light glows, ensure connector C1 terminals are clean and tight. If connector is okay, replace power mirror switch.
- Connect test light between power mirror switch connector terminal "D" (Orange wire) and ground. If test light glows, repair open in Black wire to power mirror switch. If test light does not glow, check for open in Orange wire between power mirror switch and fuse block. If circuit is okay, service multifunction alarm module. See appropriate wiring diagram in WARNING SYSTEM article.