LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1995 >> Tahoe 4D Utility, RWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Removal & Installation >> Electronic Brake Control Module >> Removal & Installation

Removal & Installation

  1. Disconnect negative battery cable. Disconnect 4 electrical connectors from EBCM. Remove 4 EBCM-to-BPMV Torx bolts. Separate EBCM from BPMV. DO NOT pry on EBCM or BPMV. Excessive force will damage EBCM.
  2. To install, reverse removal procedure. DO NOT reuse EBCM gasket or mounting bolts. Ensure gasket is properly aligned. DO NOT use any type of sealant on EBCM gasket or mating surfaces. Bleed brake system, including BPMV. See BLEEDING BRAKE SYSTEM . Tighten EBCM bolts to specification. See TORQUE SPECIFICATIONS . Perform anti-lock bulb check. Using Tech 1, revise tire size calibration.
scientia non olet · About LEMON Manuals