LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1995 >> Chevy Van G20, 5.0 H >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Controls - System/Component Tests - 7.4L) >> Miscellaneous ECM/Pcm/VCM Controls >> Transmission (C-8) >> Converter Lock-Up Signal From ECM/PCM/VCM

Converter Lock-Up Signal From ECM/PCM/VCM

WARNING: This page is about a different variant/trim than selected.
  1. Warm engine to operating temperature. Raise vehicle and support drive wheels. Support suspension where necessary to prevent damage to drive axles.
  2. Connect a test light to battery voltage. Touch TCC control driver terminal with test light. See Figure. Accelerate vehicle to 45 MPH and note test light. If test light does not illuminate, problem is a faulty ECM/PCM/VCM connector or ECM/PCM/VCM. On some models, lock-up signal may be checked at Data Link Connector (DLC) terminal "F" instead of at ECM/PCM/VCM terminal.
scientia non olet · About LEMON Manuals