Fuel Injector(s)

Disconnect fuel injector harness connector. Measure resistance across injector terminals at each injector. Resistance should be as specified. See INJECTOR RESISTANCE SPECIFICATIONS .

INJECTOR RESISTANCE SPECIFICATIONS ⁽¹⁾

Application

Ohms

2.3L ⁽²⁾

1.9-2.1

⁽¹⁾	Injector resistance specification is at 140°F (60°C).

⁽²⁾	Information not available for A/T.

NOTE: If injectors are dirty, they should be cleaned using approved injector cleaning procedure before performing INJECTOR BALANCE TEST.