LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1994 >> Forward Control 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Drive Axle - Front) >> Overhaul >> Right Axle Tube Assembly >> Disassembly

Right Axle Tube Assembly: Disassembly

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 1994 GMC Yukon, 1994 GMC Suburban, 1994 GMC Pickup, 1994 GMC Cab & Chassis, and 1994 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place mounting flange of axle tube assembly in a vise. Remove actuator solenoid and engagement switch from tube. Remove shift shaft, springs, shift fork and differential sleeve (No. 22). See Figure or Figure . Remove snap ring, connector gear (on K15/25) or washer (on K35), and thrust washer from axle shaft.
  2. Using a soft mallet, tap on flange end of axle shaft to remove axle shaft from tube. DO NOT  hammer on pilot bearing stem end of axle shaft, severe damage will result. Using a screwdriver, pry out deflector and oil seal.
  3. To remove axle bearing from tube, use Bearing Remover (J-29369-1 ) for K15/25 or (J-29369-2 ) for K35. Using appropriate puller and slide hammer, remove axle bearing.
scientia non olet · About LEMON Manuals