LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1994 >> Forward Control 6.5 Y, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overhaul - 4L60/4L60-E >> Transmission Reassembly >> Extension Housing

Extension Housing

  1. Install speed sensor wheel/speedometer gear and retaining clip on output shaft. On 4L60, if output shaft has 2 locating holes, use hole nearest yoke on Corvette only. Install "O" ring in output shaft sleeve.
  2. On all models, install output sleeve on output shaft. DO NOT  position output sleeve past machined surface of output shaft. Install seal ring on extension housing.
  3. Position extension housing on transmission case. Install retaining bolts. Install oil seal in extension housing.
  4. Install speed sensor/speedometer driven gear and fitting assembly. Install retainer and bolt. Tighten bolt to specification. See TORQUE SPECIFICATIONS  table. Install outside electrical connector and manual shift lever.
scientia non olet · About LEMON Manuals