PASS-Key(R) Lock Cylinder & Harness Test
- Remove hush panel under steering column. Disconnect PASS-Key(R) 2-pin connector in wire leading to steering column.CAUTION: Ensure correct PASS-Key(R) 2-pin connector is disconnected and not Yellow 2-pin Supplemental Inflatable Restraint (SIR) connector. PASS-Key(R) 2-pin connector has Purple/White and White/Black wires.
- Connect male and female parts to mating connectors on pigtails from Interrogator (J 35628). Insert ignition key into ignition switch. Press ON-OFF switch on interrogator to ON position. Window above key code reader should indicate electrical code for key (1 through 15) or "E" for error.
- Rotate ignition key to ensure correct code is read in all positions. If code is correct in all positions, set interrogator key code selector to same electrical code displayed in step 2). Turn ignition switch to START position.
- If code is correct only in some positions, obtain a spare key or make a replacement. Read code again. If code is correct, original key was defective. An incorrect code indicates a defective lock cylinder.
- If display window shows "E", check ignition key by inserting it in interrogator key code reader. If interrogator indicates "E", replace key. If interrogator indicates electrical Codes 1 through 15, replace lock cylinder.
Pass Key Resistance Values
| Key Resistance Number | Ohms Value |
|---|---|
| 1 | 402 |
| 2 | 523 |
| 3 | 681 |
| 4 | 887 |
| 5 | 1130 |
| 6 | 1407 |
| 7 | 1870 |
| 8 | 2370 |
| 9 | 3010 |
| 10 | 3740 |
| 11 | 4750 |
| 12 | 6040 |
| 13 | 7500 |
| 14 | 9530 |
| 15 | 11800 |