LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1993 >> APV >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overhaul - 3T40 >> Component Disassembly & Reassembly >> Transaxle Case >> Reassembly

Transaxle Case: Reassembly

  1. Install new final drive case bushing using Bushing Installer (J-28537-2) and Driver Handle (J-8092). Drive in bushing until tool bottoms. Using Seal Driver (J-26938 or J-29130) and driver handle, install new right axle seal assembly. DO NOT  damage seal guard during installation. Using a 9/16" socket, install manual shaft oil seal with lip up.
  2. Using a 1/4" drift, install new cup plug. See Figure. Cup plug should seat fully in bore. Before installing, coat ends of governor oil pipe with Loctite sealer. Install governor pipe and retaining clamp.
  3. Install parking pawl and spring, parking pawl shaft and retainer. Ensure large loop of pawl spring is positioned on right side of pawl. Coat parking pawl shaft cup plug with sealant, and install plug using a 3/8" drift.
  4. Install driven sprocket support roller bearing assembly with bearing identification facing up. Lightly tap driven sprocket support bearing into position using Bearing Installer (J-28677). Install new converter oil seal using Driver (J-28540).
scientia non olet · About LEMON Manuals