LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1992 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Central Control Module >> Trouble Shooting >> Preliminary Inspection

Preliminary Inspection

  1. Ensure LCD, A/C and CCM fuses are not open. Ensure ground G106 is clean and tight. See Figure .
  2. Check for a broken or partially broken wire inside insulation, which could cause system malfunction but prove good in a continuity/voltage check with system disconnected. These circuits may be intermittent or resistive when loaded and should be checked by monitoring the voltage drop with the system under load. Ensure any aftermarket electronic equipment is properly installed. If fault is found, repair as necessary.
  3. If no faults are found, go to SYSTEM OPERATION CHECK  or check for any DTCs that may be present. See SELF-DIAGNOSTIC SYSTEM  .
scientia non olet · About LEMON Manuals