Code 42, Elect Spark Timing W/Dis: Notes
Code 42 indicates the ECM has seen an open or short to ground in EST or by-pass circuits (DIS ignitions).
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- This test confirms Code 42 and determines if fault is hard or intermittent.
- This test checks for a normal EST ground path through the ignition module. If circuit No. 423 is shorted to ground, reading will be less than 500 ohms.
- As test light voltage touches circuit No. 424, the module should switch. This will cause the ohmmeter to "over-range" if meter is in the 1000-2000 ohm position. A higher ohm range will indicate over 5000 ohms. This test assures that the module "switched".
- If module did not switch, this step will test for a short in circuit No. 423, an open in circuit No. 424, and a faulty ignition module connection or module.
- This step confirms that Code 42 is a faulty ECM and not an intermittent problem in circuits No. 423 and 424.