Engine Controls - Tests W/Codes - 2.2L TBI: Introduction: Notes

Most engine control problems are the result of mechanical breakdowns, poor electrical connections or damaged vacuum hoses. Before considering the computer system as a possible cause of problems, perform checks and inspections covered in BASIC TESTING article. Failure to do so may result in lost diagnostic time.

If no faults were found while performing BASIC TESTING , proceed with DIAGNOSTIC PROCEDURE. If no fault codes or only a non-running Code 12 is present and driveability problems exist, proceed to H - TESTING W/O CODES article for diagnosis by symptom (i.e. ROUGH IDLE, NO START, etc.). If only intermittent codes are present, see INTERMITTENTS in H - TESTING W/O CODES article in this section.

The ECM is equipped with a self-diagnostic system, which detects system failures or abnormalities. When a malfunction occurs, ECM will illuminate the SERVICE ENGINE SOON light located on instrument panel. When malfunction is detected and light is turned on, a corresponding trouble code will be stored in ECM memory. To retrieve stored codes, see RETRIEVING CODES (NON-SCAN)  in this article. Malfunctions are recorded as HARD FAILURES or as INTERMITTENT FAILURES.