EXPERTEC TSB (88-283-6E)

WARNING: This page is about the Spectrum Base, 2D Hatchback, Automatic, which is a different variant/trim than selected.

Publication date: 1988-06-24
Reference number: 88-283-6E

EXPERTEC TSB

TECHNICAL SERVICE BULLETIN

Reference Number(s): 88-283-6E, Date of Issue: 06/24/88

ELECTROSTATIC DISCHARGE DAMAGE - TO ECM (INFO.TO PREVENT)

Model(s): 1981-88 Passenger and Light Duty Trucks with an Electronic Control Module (ECM)

Bulletin No.: Chevrolet 88-283-6E

Date: 06/24/1988

SERVICE INFORMATION

Please add the following information to 6E Section "A" Diagnostic Charts/Trouble Codes, and to Section "C1" Electronic Control Module and Sensors.

NOTE: To prevent possible Electrostatic Discharge damage: Do Not touch the ECM connector pins or soldered components on the ECM circuit board. When handling a PROM, CAL-PAK or Mem-Cal, Do Not touch the component leads, and Do Not remove integrated circuit from carrier.

Electronic components used in control systems are often designed to carry very low voltage, and are very susceptible to damage caused by electrostatic discharge. It is possible for less than 100 volts of static electricity to cause damage to some electronic components. By comparison, it takes as much as 4,000 volts for a person to even feel the zap of a static discharge.

There are several ways for a person to become statically charged. The most common methods of charging are by friction and by induction. An example of charging by friction is a person sliding across a car seat, in which a charge of as much as 25,000 volts can build up. Charging by induction occurs when a person with well insulated shoes stands near a highly charged object and momentarily touches ground.

Charges of the same polarity are drained off, leaving the person highly charged with the opposite polarity. Static charges of either type can cause damage, therefore, it is important to use care when handling and testing electronic components.