Checking Fluid Level: Sprint
- Unscrew fluid level gauge from side case of transaxle. Insert fluid level gauge through opening until bottom shoulder of threaded part of gauge rests on top of side case.
- Remove gauge and check oil level. Fluid level should be between "FULL" and "LOW" lines. If fluid level is below "LOW" line, add fluid until it reaches "FULL" line.
NOTE:
During fluid change on Sprint, clean drain plug and apply sealant (GM 1052080) to plug threads. If transaxle is cold, tighten drain plug to 18-22 ft. lbs. (24-30 N.m). If transaxle is warm, tighten drain plug to 15-18 ft. lbs. (20-24 N.m).