LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 1987 >> Chevette 4D Hatchback, Automatic >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Column >> Reassembly >> Bearing Housing

Bearing Housing

  1. On General Motors models (if equipped), install key release lever and spring into shroud and install retainer plate. On all models, use an arbor press to install bearings into housing (if removed). Install lock shoe springs, lock shoes and shoe pin into housing. Using a .180" (4.5 mm) pin, align shoes for pin installation.
  2. Relieve load on release lever, and install spring, release lever, and pin into bearing housing. Install drive shaft into housing. Lightly tap sector onto shaft, far enough to bottom on drive shaft.
  3. Install lock bolt and engage with sector cam surface. Install rack and spring. Block tooth on rack to engage block tooth on sector. Install external tilt release lever.
  4. Install lock bolt spring, and spring retaining screw. Tighten screw to 35 INCH lbs. (4 N.m). Slide bowl onto jacket.
scientia non olet · About LEMON Manuals