Replace and Program Control Module (K160 Brake System Control Module with A104 Brake Master Cylinder)

To program a replacement control module, perform the following procedure:

1. Ignition/Vehicle OFF.
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select K160 Brake System Control Module - Programming and follow the on-screen instructions.
4. Perform the Hydraulic Brake System Bleeding procedure refer to Hydraulic Brake System Bleeding
5. Clear DTCs.
6. If ABS, Traction Control and/or Stabilitrak indicators or Brake Related Messages are ON after performing programming and setup, do the following:
   1. Disconnect the scan tool from the X84 Data Link Connector.
   2. Ignition/Vehicle OFF, all access doors closed, all vehicle systems OFF, and all keys at least 3 m (9.8 ft) away from the vehicle. It may take up to 10 min to power down.
   3. Ignition ON/Vehicle In Service Mode, verify ABS, Traction Control and/or Stabilitrak indicators or Brake Messages are Off. If not, repeat the above step to make sure the vehicle is in sleep mode.
   4. Clear DTCs.