Removal Procedure
- Remove the 3rd row seat. 3rd Row Seat Removal and Installation
- Disable the SIR system. SIR Disabling and Enabling
- NOTE:
Left side shown, right side similar.
Using a flat-bladed plastic trim tool, release the retaining clips.
- Pull upward from both sides of right side the rear side door sill garnish molding (1) to disengage retaining clips front to rear.
- {If equipped} Disconnect the electrical connector.
- Rear Side Door Sill Garnish Molding - Right Side (1) - Remove
- NOTE:
Left side shown, right side similar.
Place the right side rear seat (1) in the fold and tumble position.
Liftgate Lock Striker Cover (1) - Remove
Use a flat bladed plastic tool to disengage retaining clips on the rear end trim finish panel (1).
- Rear End Trim Finish Panel (1) - Remove
- NOTE:
Left side shown, right side similar.
Rear Seat Belt Retractor Sleeve - Right Side (1) - Reposition
- Rear Seat Belt Anchor Plate Bolt - Right Side (2) - Remove
- NOTE:
Left side shown, right side similar.
Quarter Window Trim Finish Panel Bolt Cap - Right Side (2) - Remove
- Quarter Window Trim Finish Panel Bolt - Right Side (3) - Remove
- NOTE:
Left side shown, right side similar.
Using a flat-bladed plastic trim tool, release the retaining clips.
- Body Lock Pillar Upper Trim Panel - Right Side (1) - Reposition
- NOTE:
Left side shown, right side similar.
Liftgate Weatherstrip - Right Side (1) - Reposition
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Body Side Rear Window Garnish Molding - Right Side (2) - Reposition
- NOTE:
Left side shown, right side similar.
Body Rear Corner Upper Garnish Molding Bolt - Right Side (1) - Remove
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Body Rear Corner Upper Garnish Molding - Right Side (2) - Remove
- NOTE:
Left side shown, right side similar.
Electrical Connector - Right Side (1) - Disconnect
- Wiring Harness Retainer - Right Side (2) - Remove
- NOTE:
Left side shown, right side similar.
Remove the right side lower 3rd row seat belt retractor bolt (1).
- NOTE:
Left side shown, right side similar.
Using a flat-bladed plastic trim tool, release the retaining clips.
- Rear Seat Belt Opening Bezel - Right Side (1) - Remove
- NOTE:
Left side shown, right side similar.
3rd Row Seat Belt Retractor Anchor Cover - Right Side (1) - Open
- Remove the right side upper 3rd row seat belt retractor bolt (2).
- NOTE:
Left side shown, right side similar.
Convenience Net Retainer - Right Side (1) - Remove
- NOTE:
Left side shown, right side similar.
Cargo Tie Down Loop Bolt Cap - Right Side (1) - Open
- Cargo Tie Down Loop Bolt - Right Side (2) - Remove
- Cargo Tie Down Loop - Right Side (3) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
-
NOTE:
Feed the rear seat belt opening bezel and 3rd row seat belt through the quarter lower rear trim panel.
Quarter Lower Rear Trim Panel (1) - Remove
Disconnect the electrical connectors (1).
- Remove the wiring harness retainers (2).
Disconnect the electrical connectors.
- Accessory AC and DC Power Control Module Nut (1) - Remove [3x]
- Accessory AC and DC Power Control Module (2) - Remove