Removal Procedure

Open both front and rear side doors.
Courtesy of GENERAL MOTORS COMPANY

Front Wheelhouse Liner Bolt (1) - Remove [3x]
Rocker Panel Protector (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Wheelhouse Liner Bolt - Left Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Wheelhouse Liner Retainer (1) - Remove
Front Wheelhouse Liner (2) - Reposition
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Remove only the outer rear tire front air deflector bolt. The rear tire front air deflector will be repositioned with the rear wheelhouse liner.

Rear Tire Front Air Deflector Bolt (1) - Remove
Rear Wheelhouse Liner Retainer (2) - Remove
Rear Wheelhouse Liner (3) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Apply a double layer of masking tape around the perimeter of the painted surfaces.
Using an appropriate trim tool, release the lower rocker panel molding retainers (1) and pull the rocker panel molding (2) away from the body side outer panel.
Using an appropriate trim tool, release the upper rocker panel molding retainers (1) and pull the rocker panel molding (2) away from the body side outer panel.
Rocker Panel Molding (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Release the 2 retainer tabs and remove the low frequency body side antenna (1).
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Release the retaining tabs on the ignition lock key transmitter antenna bracket (1).