Installation Procedure
WARNING: This page is about a different car, the 2020 Cadillac XT5. However, it is still accessible from the selected car via links, so may be relevant.
Position the clutch control module (1) onto the rear axle.
Reconnect the electrical connector (1) to the clutch control module.
- CAUTION:
Refer to Fastener Caution .
NOTE:Apply loctite before installing bolts.
Install the clutch control module bracket bolts (1). Tighten to 6 N.m (53 lb in).
- Install the rear drive axle assembly. Differential Carrier Assembly Replacement
- Remove the support and lower the vehicle.
- Reprogram the clutch control module. Control Module References