Removal Procedure

WARNING:

Refer to SIR Inflator Module Handling and Storage Warning .

WARNING:

After installation of the steering wheel airbag module to the steering wheel, slightly pull the module outward. If there is no give on the airbag module then it is secured correctly. If the airbag module is not fully attached personal injury could result.

Disable the SIR system. SIR Disabling and Enabling
Courtesy of GENERAL MOTORS COMPANY

Use a flat bladed plastic trim tool to depress the steering wheel airbag access hole cover detents to remove the 2 steering wheel airbag access hole covers (1).
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Airbag Bolt (1) - Remove [2x]
Release the connector position assurance (CPA) retainer.
Disconnect the electrical connectors.
Steering Wheel Airbag (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Loosen the steering wheel bolt (1) so that 2 - 3 threads are engaged.
Disconnect the electrical connector.
Wiggle the steering wheel until the wheel disengages completely.
Steering Wheel Bolt (1) - Remove
Steering Wheel (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Bolt (1) @ Automatic Transmission Manual Shift Auxiliary Position Switch - Remove [4x]
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Bolt (1) @ Steering Wheel Shroud - Remove [4x]
Courtesy of GENERAL MOTORS COMPANY

Steering Wheel Shroud (1) - Remove
Disconnect the electrical connectors.
Courtesy of GENERAL MOTORS COMPANY

Remove the heated steering wheel module (1) from the steering wheel shroud (2).