Installation Procedure
Parking Assist Control Module (2) - Install
- Parking Assist Control Module Nut (1) - Install and tighten [2x] Fastener Specifications
- Connect the electrical connectors.
- Perform the necessary programming and setup procedure: Control Module References
Rear Compartment Side Trim Insulator Retainer (1) - Install [4x]
- Rear Compartment Side Trim-Right Side (2) - Install
Rear End Trim Finish Panel (1) - Install
Rear End Trim Finish Panel Opening Cover (1) - Install
Rear Compartment Floor Panel Trim (1) - Install
Cargo Tie Down Loop (3) - Install [2x]
- Cargo Tie Down Loop Bolt (2) - Install and tighten [2x] - Fastener Specifications
- Cargo Tie Down Loop Bolt Cap (1) - Install [2x]
CAUTION:
Refer to Fastener Caution .