Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Use a small flat-bladed tool to disengage integral tabs on cargo tie down loop bolt cap

Cargo Tie Down Loop Bolt Cap (1) - Remove [2x]
Cargo Tie Down Loop Bolt (2) - Remove [2x]
Cargo Tie Down Loop (3) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Floor Panel Trim (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Use a small flat-bladed tool to disengage integral tabs on rear end trim finish panel opening cover (1).
Rear End Trim Finish Panel Opening Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

With a flat bladed plastic trim tool, disengage the integral clips.
Rear End Trim Finish Panel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Carefully manipulate the deck lid hinge opening of the rear compartment side trim past the hinge cover.

Rear Compartment Side Trim Insulator Retainer (1) - Remove [4x]
Rear Compartment Side Trim-Left Side (2) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) @ Electronic Suspension Control Module - Disconnect
Disconnect the wiring harness retainers and reposition the harness as necessary.
Courtesy of GENERAL MOTORS COMPANY

Release the retaining tab (2) and slide the electronic suspension control module (1) out of the rear body fuse block bracket.