Fastener Specifications
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2020 GMC Yukon XL, 2020 GMC Yukon, 2020 Chevrolet Tahoe, 2020 Chevrolet Suburban, and 2020 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Axle Shaft Seals |
| Differential Adjuster Nut Lock Ring |
| Drive Pinion Gear Collapsible Spacer |
| Drive Pinion Gear Nut |
| Drive Pinion Gear Washer |
| Front Differential Carrier Gasket |
| Front Differential Carrier Cover Gasket |
| Front Drive Axle Inner Shaft Retaining Ring |
| Front Drive Axle Inner Shaft Seal |
| Pinion Gear Shaft Lock Pin |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Ring Gear Bolts - 8.25 Axle | 120 N.m (89 lb ft) |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Differential Carrier Assembly Case Bolts 8.25 Axle | 73 N.m (54 lb ft) |
| Differential Carrier Assembly Mounting Bolts and Nuts - 8.25 Axle - Right Side | 100 N.m (74 lb ft) |
| Differential Carrier Bracket to Frame Nuts - 8.25 Axle | 100 N.m (74 lb ft) |
| Front Differential Carrier Shield Bolts | 20 N.m (15 lb ft) |
| Front Drive Axle Actuator | 30 N.m (22 lb ft) |
| Inner Shaft Housing to Bracket Nuts | 100 N.m (74 lb ft) |
| Inner Shaft Housing to Differential Carrier Assembly Bolts 8.25 Axle | 55 N.m (41 lb ft) |
| Plug, Fill 8.25 Axle | 33 N.m (24 lb ft) |
| Plug, Drain 8.25 Axle | 45 N.m (33 lb ft) |
| Stabilizer Link Nut | 18 N.m (13 lb ft) |
| Vent Hose Connector | 28 N.m (21 lb ft) |
| Wheel Drive Shaft Inboard Flange Bolts | 79 N.m (58 lb ft) |
| Wheel Drive Shaft to Front Hub Nut | 240 N.m (177 lb ft) |
| Yoke Retainer Bolts | 25 N.m (18 lb ft) |