Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2020 GMC Yukon XL, 2020 GMC Yukon, 2020 Chevrolet Tahoe, 2020 Chevrolet Suburban, and 2020 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
Battery (3) - Install
- Battery Hold Down Retainer (2) - Install
- Battery Hold Down Bolt (1) - Install and tighten 25 N.m (18 lb ft)
Position the radiator surge tank (3) back into place. Radiator Surge Tank Replacement (L83 L86)
Battery Distribution Engine Compartment Fuse Block (2) - Install - Battery Distribution Engine Compartment Fuse Block Replacement (with K4B, KHB) , or Battery Distribution Engine Compartment Fuse Block Replacement (NV8) , or Battery Distribution Engine Compartment Fuse Block Replacement (without K4B)
- Retaining Tab (1) - Engage [2x]
- Connect the wiring harness connector at the right side of the fuse block.
Battery Positive Post Clamp Nut (1) - Tighten 6N.m (53 lb in)
Battery Positive Cable (3) - Install
- Battery Positive Cable Nut (2) - Install and tighten 15 N.m (11 lb ft)
- Battery Distribution Engine Compartment Fuse Block Cover (1) - Install
- Retainer Clip (4) - Engage
Front Fender Rear Upper Brace (4) - Install - Front Fender Rear Upper Brace Replacement
- Connect the negative battery cable. Battery Negative Cable Disconnection and Connection (Dual Battery) , or Battery Negative Cable Disconnection and Connection (Single Battery)
CAUTION:
Refer to Fastener Caution