Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2020 GMC Yukon XL, 2020 GMC Yukon, 2020 Chevrolet Tahoe, 2020 Chevrolet Suburban, and 2020 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
- Lightly lubricate the rear wheel speed sensor O-ring with rear axle lubricant. Refer to Adhesives, Fluids, Lubricants, and Sealers .
Install the rear wheel speed sensor assembly to the rear axle.
- Install the rear wheel speed sensor bolt (1) and tighten to 13 N.m (115 lb in).
Install the rear wheel speed sensor harness retainer (1) to the rear axle.
Connect the rear wheel speed sensor electrical connector and install the retainers (1) to the frame rail.
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Perform the Diagnostic System Check - Vehicle .
CAUTION:
Refer to Fastener Caution .