K5 Automatic Level Control Module
WARNING: This page is about a different car, the 2023 GMC Hummer EV. However, it is still accessible from the selected car via links, so may be relevant.
The K5 Automatic Level Control Module controls the system functions and detects failures. It relies on data from the following modules to function properly:
- K9 Body Control Module (BCM)
- K160 Electronic Brake Control Module (EBCM)
- A11 Center Stack Module (CSM)
- P16 Instrument Panel Cluster (IPC)
- K43 Electronic Power Steering Module (EPS)
- K19 Semi Active Damping System (SADS)
- K36 Sensing and Diagnostic Module (SDM)
The K5 Automatic Level Control Module utilizes the following vehicle parameters alone or in combination with one another to establish a target ride height that is other than that selected by the driver or to control the type of movement (i.e. fast, slow, unattended) :
- Vehicle Speed
- Lateral Acceleration
- Longitudinal Acceleration
- Throttle Position
- Cruise Control Status
- Transmission Range Selection Status
- Stability Control System Status
- Semi-Active Damping System Status
- Vehicle Power Mode
- Suspension Position Sensors
- Air Spring Pressures
- Vehicle Load Shed
- Propulsion Active State
- Door/hood State
- Four-Wheel Drive State
- Steering Wheel Angle
- Alignment Mode
- Service Mode
- Seat Belt
- Logistics Mode
- Vehicle Battery Voltage
- Trailer Connection
- System Thermal Estimate
- Vehicle Load
- Spring Pressures