Fastener Specifications
WARNING: This page is about a different car, the 2020 Cadillac CT6. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Engine Coolant Air Bleed Pipe Seal |
| Engine Coolant Manifold Gasket |
| Engine Coolant Thermostat Housing Seal |
| Engine Oil Cooler Adapter Gasket |
| Engine Oil Cooler Gasket |
| Engine Oil Cooler Seal |
| Heater Inlet and Outlet Pipe Gasket |
| Turbocharger Coolant Feed And Return Pipe Gasket |
| Turbocharger Coolant Feed And Return Pipe Washer |
| Water Inlet Gasket |
| Water Outlet Seal |
| Water Pump Gasket |
| Water Pump Housing Gasket |
| Water Pump Inlet Pipe Seal |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Auxiliary Radiator Front Duct Bolt | 7 N.m (62 lb in) |
| Auxiliary Radiator Front Duct Nut | 7 N.m (62 lb in) |
| Charge Air Cooler Bolt | 8.5 N.m (75 lb in) |
| Charge Air Cooler Bolt @ Charge Air Cooler Radiator (LTA) | 6 N.m (53 lb in) |
| Charge Air Cooler Bracket Nut | 9 N.m (80 lb in) |
| Charger Air Cooler Coolant Hose Connector Bolt | 10 N.m (89 lb in) |
| Charge Air Cooler Coolant Pump Clamp Bolt | 9 N.m (80 lb in) |
| Charge Air Cooler Coolant Pump Nut | 9 N.m (80 lb in) |
| Charger Air Cooler Inlet Hose Fitting Nut | 9 N.m (80 lb in) |
| Charge Air Cooler Inlet Air Tube Clamp | 4 N.m (35 lb in) |
| Charge Air Cooler Inlet Pipe Bolt | 9 N.m (80 lb in) |
| Charge Air Cooler Nut | 8.5 N.m (75 lb in) |
| Engine Coolant Air Bleed Pipe Bolt | 10 N.m (89 lb in) |
| Engine Coolant Air Bleed Valve | 12 N.m (106 lb in) |
| Engine Coolant Fan Bolt | 6 N.m (53 lb in) |
| Engine Coolant Fan Shroud Bolt | 5.1 N.m (45 lb in) |
| Engine Coolant Fan Motor Bolt | 4.0 - 7.5 N.m (53 - 66 lb in) |
| Engine Coolant Heater | 50 N.m (37 lb ft) |
| Engine Coolant Temperature Sensor | 9 N.m (80 lb in) |
| Engine Coolant Thermostat Housing Bolt | 10 N.m (89 lb in) |
| Engine Coolant Thermostat Housing Pipe Bolt | 9 N.m (80 lb in) |
| Engine Oil Cooler Adapter Bolt | 10 N.m (89 lb in) |
| Engine Oil Cooler Coolant Inlet Hose Bracket Bolt | 22 N.m (16 lb ft) |
| Engine Oil Cooler Inlet Pipe Bolt | 10 N.m (89 lb in) |
| Engine Oil Cooler Pipe Bolt | 10 N.m (89 lb in) |
| Engine Oil Cooler Pipe Quick Connect Fitting | 35 N.m (26 lb ft) |
| Heater Inlet and Outlet Pipe Bolt | 9 N.m (80 lb in) |
| Heater Inlet and Outlet Pipe Bracket Bolt | 9 N.m (80 lb in) |
| Heater Water Bypass Inlet Hose Bolt | 22 N.m (16 lb ft) |
| Heater Water Bypass Inlet Hose Bracket Bolt | 22 N.m (16 lb ft) |
| Radiator Air Front Lower Baffle Bolt | 2.5 N.m (22 lb in) |
| Radiator Air Upper Baffle Bolt @ Front Bumper Impact Bar | 2.5 N.m (22 lb in) |
| Radiator Air Upper Baffle Bolt @ Front End Upper Tie Bar | 4.0 N.m (35 lb in) |
| Radiator Inlet Pipe Bolt (LTA) | 9 N.m (80 lb in) |
| Radiator Lower Bracket Bolt | 22 N.m (16 lb ft) |
| Radiator Surge Tank Bolt | 9 N.m (80 lb in) |
| Radiator Upper Bracket Bolt | 9 N.m (80 lb in) |
| Turbocharger Coolant Feed And Return Pipe Bolt (LTA) | 8.5 N.m (75 lb in) |
| Turbocharger Coolant Feed And Return Pipe Bolt (Hollow Screw} | 35 N.m (26 lb ft) |
| Water Outlet Bolt | 10 N.m (89 lb in) |
| Water Pump Bolt (LGX, LTA) | 15 N.m (11 lb ft) |
| Water Pump Inlet Pipe Bolt | 9 N.m (80 lb in) |
| Water Pump Pulley Bolt | 10 N.m (89 lb in) |