Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Column Lock Module (2) - Install

CAUTION:

Refer to Fastener Caution .

Steering Column Lock Control Module Bolt (1) - Install and tighten [4x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Connect the electrical connector. (1)
Install the steering column lock control module protector (2).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Connect the wiring harness retainers (1) and install the wiring harness.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Start ALL bolts by hand before breaking the bolt heads off or misalignment of the steering column lock control module protector may occur.

Steering Column Lock Control Module Protector Bolt (1) - Install NEW and hand tighten [4x]
Tighten the 4 steering column lock control module protector bolts (1) until the bolt heads break off. Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Floor Front Air Outlet Duct - Left Side (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Floor Front Air Outlet Duct Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Knee Bolster Deflector (2) - Install
Instrument Panel Tie Bar Brace Bolt (1) - Install and tighten [3x] - Fastener Specifications
Connect and position the wiring harness.
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Knee Bolster (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Data Link Connector Bolt (1) - Install and tighten [2x] - Fastener Specifications
Instrument Panel Knee Bolster Bolt (2) - Install and tighten [3x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Center Trim Pad (1) - Install
Return the steering column to its original position.
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Lower Trim Panel Insulator (1) - Install
Connect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Install the tabs into the instrument panel lower trim panel insulator (1).
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Lower Trim Panel Insulator Retainer (1) - Install
Instrument Panel Insulator Bolt (2) - Install and tighten [2x] - Fastener Specifications
Instrument Panel Insulator Nut (3) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Attach the hood primary latch release cable end retainer to the hood primary latch release cable handle (1).
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Outer Trim Cover - Left Side (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Connect the electrical connector.
Instrument Panel Lower Airbag - Driver Side (2) - Install
Instrument Panel Lower Airbag Nut (1) - Install and tighten [2x] - Fastener Specifications
If equipped, install the fuse for the steering column lock control module. The fuse is found in the instrument panel fuse block and is labeled ESCL. Electrical Center Identification Views
Enable the SIR System. SIR Disabling and Enabling
Program the steering column lock control module. Control Module References
Center the steering angle sensor. Steering Wheel Angle Sensor Centering
If the battery was disconnected for steering column replacement, wait for all modules to fall asleep. This can be done by closing all vehicle closures (doors, trunk, hood) and waiting for three minutes without actuating any vehicle functions or pushing any buttons.
Perform functionality check of tilt and telescoping features.