LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2019 >> XTS Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Parking Brake System) >> Repair Instructions >> Electronic Parking Brake Control Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2018 Cadillac XTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Block the drive wheels.
  2. Disable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Disabling 
  3. Place the ignition in the OFF position.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Remove the left rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (With J64)Tire and Wheel Removal and Installation (With J55) .
  6. Remove the left rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
  7. GM2752677Courtesy of GENERAL MOTORS COMPANY

    Remove the parking brake cable nut (1).

  8. Disconnect the electronic parking brake control module electrical connector.
  9. GM2752681Courtesy of GENERAL MOTORS COMPANY

    Remove the electronic parking brake control module nuts (1).

  10. Remove the electronic parking brake control module and bracket assembly.
  11. Remove the electronic parking brake control modulator bracket, if necessary. Refer to Electronic Parking Brake Control Modulator Bracket Replacement .
scientia non olet · About LEMON Manuals