LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2019 >> CTS Base, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Starting System And Charging System - Repair Instructions >> Repair Instructions >> Battery Positive Cable Replacement >> Installation Procedure

Installation Procedure

  1. Install the engine compartment battery positive cable (2) through the pass through opening and install the battery positive cable grommet (1).
    GM3461472Courtesy of GENERAL MOTORS COMPANY
  2. Attach the battery positive cable retainers (3) to the plenum studs.
  3. Install the battery positive cable (4) to the body harness and wheel house with the retainers (3).
    GM3461537Courtesy of GENERAL MOTORS COMPANY
  4. Install the battery positive cable retainer (2), to the radiator surge tank (1).
  5. Attach the following to the pre-fuse block:
    GM2827728Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    • Starter Solenoid Cable (4).
    • Battery Positive Barrel Fastener (3). Tighten to 15 N.m (11 lb ft).
    • Pre-Fuse Block Cover (2).
    • Battery Jumper Post Cover (1).
  6. Reposition the brake pressure modulator valve. Refer to Brake Pressure Modulator Valve Replacement .
  7. Install the front plenum panel. Refer to Plenum Front Panel Replacement .
  8. Attach the battery positive cable (2) to the right side passenger compartment with the retainers (1).
    GM2827724Courtesy of GENERAL MOTORS COMPANY
  9. Position the battery positive cable (2) along the rear seat area with the retainers (1).
    GM2827721Courtesy of GENERAL MOTORS COMPANY
  10. Install the battery positive cable (2) along the left rear seat with the retainers (1).
    GM3461473Courtesy of GENERAL MOTORS COMPANY
  11. Position the front and rear carpet back into position.
  12. Install the front side door sill garnish molding. Refer to Front Side Door Sill Garnish Molding Replacement .
  13. Install the rear side door sill garnish molding left and right. Refer to Rear Side Door Sill Garnish Molding Replacement .
  14. Install the center pillar lower trim panel. Refer to Center Pillar Lower Trim Panel Replacement .
  15. Install the rear seat cushion. Refer to Rear Seat Cushion Removal and Installation .
  16. Install the rear seat back bolster. Refer to Rear Seat Back Bolster Replacement .
  17. Install the passenger seat. Refer to Front Seat Removal and Installation .
  18. Install the battery positive cable (2) along the left rear compartment area with the retainers (1).
    GM3461475Courtesy of GENERAL MOTORS COMPANY
  19. Install the battery positive cable terminal (1) to the battery fuse block stud and tighten the fastener (2) to 12 N.m (106 lb in).
    GM3461476Courtesy of GENERAL MOTORS COMPANY
  20. Install the battery fuse block cover (3).
  21. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (without KL9) , or Battery Negative Cable Disconnection and Connection (with KL9) .
  22. Install the left side rear compartment trim panel. Refer to Rear Compartment Side Trim Replacement - Left Side .
scientia non olet · About LEMON Manuals