Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Position the starter motor (2) to the engine block.

CAUTION:

Install the starter motor mounting fasteners (1) and tighten to 58 N.m (43 lb ft).
Courtesy of GENERAL MOTORS COMPANY

Install the battery positive cable and engine harness connector to the starter and tighten the battery positive cable fastener (1) to 9 N.m (80 lb in).
Install the engine harness connector to the starter solenoid.
Courtesy of GENERAL MOTORS COMPANY

Install the starter heat shield (2) and tighten the fastener (1) to 5 N.m (44 lb in).
Install the knock sensor - bank 2. Knock Sensor Replacement - Bank 2 (LFX FWD)
Install the front three-way catalytic converter. Three-Way Catalytic Converter Replacement (Front-LFX)Three-Way Catalytic Converter Replacement (Rear-LFX)
Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .